Heat recovery unit Ambientika advanced+ D160mm

Description

Heat recovery unit Ambientika advanced+ with 160 mm diameter hole. With integrated sensor technology.

Handling

On/off button + speed control button. The electrical contacts for both buttons (on/off and speed control) can also be mounted on the wall. This device can also be connected to a timer.

The timer button can be pressed as needed, the fan then runs at full load for 20 minutes and then switches back to heat recovery mode to dry out any moisture that accumulates in the walls.

Placement

If more than one appliance is installed, they should be installed as far apart as possible. This ventilates the whole living space, giving the most effective ventilation effect. One appliance covers approximately 30 m² of living space.

Function

The product is equipped with a ceramic heat exchanger that stores heat when the air is exhausted from the room and transfers the heat stored in the heat exchanger to the incoming air when the air is exhausted from the outside. The heat exchanger shall be wall-mounted. The pipe inside which the ceramic heat exchanger is located shall be fitted with walls having a maximum thickness of 400/500 mm. The pipe may be shortened to a minimum of 250 mm.

Equipment

• Humidity and light sensors;
  
• Device has various settings and programs;
• The device can be connected via cable to other 15 devices
• The electrical contacts of the two buttons (On /Off and Speed control) can also be wall mounted;
• It is also possible to connect the product to the home automation network (Building automation);
• Heat recovery efficiency up to 93%;
• Made of high-quality resistant materials of aesthetic excellence;
• Double separate filters for inflowing and outgoing air, easily removable and washable;
• No condensate discharge required;
• Alternating exhaust and inflow airflow;
• Electronically commutated motor (Brushless);
• Reduced power consumption;
• Silent operation;
• It is possible to duct the exhaust air with a tube of the same diameter to a distance of up to 3 meters. For ducting the exhaust air with the necessity of deviation, the maximum length of the duct (including a 90° bend) will be of 2.5 meters;
  
• Easily removable and washable filters and heat exchanger;
• Usable for replacement of an existing ejector with minimal intervention

Managing

Included in the package:

• 2x - G3 filters
• 1x - Minimal exterior hood
• 1x - Installation model
• 1x - Remote control